Shop

Surilli Basic Board – ATSAMD21G18 ARM Cortex M0, 32Bit

 1,250.00

Category:

Description

Surilli Basic M0 32 bit Microcontroller Baord:

Surilli Basic is the new ARM based development board from Silverback, it is thin, light, and lets you fly. This is the Basic, it has a prototyping space over it.?At the Surilli Basic M0’s heart is an ATSAMD21G18 ARM Cortex M0 processor, clocked at 48MHz and at 3.3V logic, the same controller used in the new Arduino M0. This chip has 256K of FLASH (8x more than the Atmega328 or 32u4) and 32K of RAM (16x as much)! This chip comes with built in USB so it has USB-to-Serial program & debug capability built in with no need for an FTDI-like chip.

To make it easy to use for portable projects, we added a connector for any of 3.7V Lithium polymer batteries and built in battery charging. You don’t need a battery, it will run just fine straight from the USB 2.0. But, if you do have a battery, you can take it on the go, then plug in the USB to recharge. The Surilli Basic will automatically switch over to USB power when it?s available.

Specification:

Here’s some handy specs! Like Surilli Basic M0 you get:

  1. Measures 62mm x 23mm x 8mm without headers soldered in
  2. Light weight – 4.5 grams
  3. ATSAMD21G18 @ 48MHz with 3.3V logic/power
  4. 256KB of FLASH 32KB of RAM
  5. No EEPROM
  6. 768 KHz crystal for clock generation & RTC
  7. 3V regulator with 500mA peak current output
  8. USB native support, comes with USB bootloader and serial port debugging
  9. Available pins – 20 GPIO pins
  10. Hardware Serial, hardware I2C, hardware SPI support
  11. PWM outputs on all pins
  12. 6 x 12-bit analog inputs
  13. 1 x 10-bit analog output (DAC)
  14. Built in 100mA li/poly charger with charging status indicator LED
  15. Pin #13 red LED for general purpose blinking
  16. Power/enable pin
  17. 4×2 power pins header
  18. 2 mounting holes
  19. Reset button

Surilli Basic M0 has some extra space left over, so there is a tiny little prototyping area. If you just need to attach a button or sensor, you may be able to skip out on a breadboard and wire it directly on it. Comes fully assembled and tested, with a USB bootloader that lets you quickly use it with the Arduino IDE.

Data Sheets:

Surilli Basic Datasheet

Microcontroller Datasheet

 

Tutorials:

Online Surilli Tutorials at Hackster

Support:

Online support through

Email: support@surilli.io